Medium push-pull Solenoid arrives at Adafruit
Hobbyists, makers or developers looking for a push pull solenoid to complete their 5 or 6 volt project may be interested to know that Adafruit have announced the arrival of a medium-sized push pull solenoid which is now available to purchase priced at $7.50.
If you have not used the solenoids before a small device is basically an electromagnet that can be triggered at will depending on certain variables. When the coil is energised, the slug is pulled into the center of the coil. This makes the solenoid able to pull from one end, or push from the other depending on your needs and requirements.
“This solenoid in particular is chunkier than our little 5V one, with a 27mm long body, 10mm long throw, and a #8216captive#8217 armature with a return spring. This means that when activated with up to 6VDC, the solenoid moves and then the voltage is removed, it springs back to the original position, which is quite handy. Many lower cost solenoids are only push type or only pull type and may not have a captive armature (it#8217ll fall out!) or don#8217t have a return spring.
You#8217ll need to power this here solenoid with about 6VDC (you don#8217t have to be exact, 5 to 6V will work fine) and ka-pow, it#8217s now a magnet. Turn off the power and it reverts back to a normal chunk of metal. Since it#8217s a coil, you#8217ll need to use a motor or solenoid driver with kick-back protection. These draw quite a bit of current, 800mA at 5V and 1 Amp at 6V so you#8217ll want a good strong driver. Our Crickit boards will work well if you use a motor port”
More details and to purchase the new solenoids just arrived at Adafruit jump over to the official online store by following the link below.